IP Phone Administrator Guide Operational Features

Operational Features

Use the following procedure to configure the Park/Pickup call feature using the programmable configuration method and the configuration files.

Configuration Files

For specific parameters you can set in the configuration files, see Appendix A, the section,

“Softkey Settings for 480i and 480i CT” on page A-94 and “Programmable Key Settings for 9112i and 9133i” on page A-100.

Programmable Configuration Using the Aastra Web UI

On the 480i/480i CT, you configure a Park and/or Pickup key at Operation->Softkeys and XML. You enter a key label, and value for a specific line on the phone. The default state of the Park configuration is "connected". The default state of the Pickup configuration is "idle, outgoing".

The 480i CT handsets use the park/pickup configuration enabled at Operation->Handset Keys in the Aastra Web UI. If Park or Pickup are enabled on more than one line on the base unit, the 480i handset uses the first programmable configuration.

For example, if line 1 and line 6 are configured for park, the 480i CT handset uses the configuration set for line 1 to park a call.

On the 9112i/9133i, you configure a Park and/or Pickup key at Operation->Programmable Keys, and then enter the appropriate value (and specify a line for the 9133i).

Note: Applicable values depend on the server in your network (Asterisk,

BroadWorks, Sylantro, ININ PBX. See the table “Park/Pickup Call

Server Configuration Values” on page 5-46.

Use the following procedure to configure the Park/Pickup call feature using the programmable configuration method and the Aastra Web UI.

5-52

41-001129-00 Rev 09, Release 1.4.1

Page 164
Image 164
Aastra Telecom 480I CT manual Programmable Configuration Using the Aastra Web UI, Server Configuration Values on