AGFA 2100 manual ROM Read-Only Memory, Recalling Factory Default Values from ROM

4.3.2 ROM (Read-Only Memory)

Read-only memory contains default values that are set at the factory. They are called default values because they are stored in ROM and cannot be changed. You can load these default values into operating memory while in Menu Mode using the procedure shown in Table 4–3.

NOTE: Default values loaded from ROM are temporary values, and are affected if the printer receives a reset command or is powered off. If you want to retain the default values, you must save them in NVRAM (see Section 4.3.3).

Table 4–3: Recalling Factory Default Values from ROM

Operation				Display Reads
1. Press		On Line	to place the	00 READY
printer	off line.
— The On Line indicator
shuts off.

2.	Press	Menu	to place the		FONT/FEED LAYOUT
	printer	in	Menu Mode.
					LOAD<–ROM FONT/F
3.	Press / once.
4.	Press			to	OK (momentarily)
		rEnter			#
	load the default				LOAD<–ROM FONT/F
	values from ROM.
5.	Press	On Line		to place	00 READY

the printer on line.

—The On Line indicator lights.

4–8DEClaser 2100 Printer Operator's Guide