Agilent Technologies L4400 manual Connecting the Terminal Block Support Sleeve

1Introduction to the L4400 Series LXI Instruments

4.Install the second L4400 instrument (if present) in the shelf area adjacent to the first instrument. If only one instrument is installed, install a filler panel on the front edge of the unused area. Insert two M4x8 flat head screws (item 1) upward through the bottom of the shelf and into the panel.

5.Connect the instrument power cord, LAN cable, and GPIB cable if present.

6.For instruments that have accompanying terminal blocks, partially remove the instrument sub- assembly from the instrument (carrier) by loosening the spring- loaded mounting screws (Figure 1- 5). Remove the support sleeve from the terminal block. Locate and remove the flat head screws from the sleeve and remove the pan head screw from between the instrument’s D- sub connectors (Figure 1- 5). Connect the sleeve to the instrument using the flat head and pan head screws as shown. Reconnect the sub- assembly.

	spring-loaded
	mounting screws
pan head screw
instrument sub-assembly
flat head screws
terminal block
support sleeve	pan head screw
	flat head screws

Figure 1-5. Connecting the Terminal Block Support Sleeve.

N O TE	Refer to Chapters 4-10 for information on Terminal Block wiring and
	connecting the terminal block to the instrument.

10 L4400 User’s Guide