Chapter 8
Powering On the Stack
This chapter contains the following procedures:
“Powering On the Switches Individually” on page 102
“Powering On the Switches Simultaneously” on page 104
“Verifying the Stack” on page 106
Perform “Powering On the Switches Individually” on page 102 if you want to control the assignment of the ID numbers to the switches of the stack. The numbers are assigned in the order in which you power on the units.
Otherwise, perform “Powering On the Switches Simultaneously” on page 104 to have the switches assign the numbers automatically.
After the ID numbers are assigned, you may change them with the STACK
RENUMBER command, described in the Software Reference: AlliedWare
Plus Operating System for x510 Series.
Caution
You should not change the ID numbers of the switches after you begin to configure the parameter settings. Otherwise, the stack might assign configuration settings to the wrong units.
101
