Allied Telesis AT-X510DP-52GTX manual Figures

Figures

Figure 1: Front Panel of the AT-x510DP-52GTX Switch	18
Figure 2: Back Panel of the Switch	18
Figure 3: AT-x510DP-52GTX Management Panel	19
Figure 4: LEDs for the 10/100/1000Base-T Ports	25
Figure 5: SFP+ Slot LEDs	26
Figure 6: Switch ID LED	28
Figure 7: Switch ID LED	28
Figure 8: Switch ID LEDs in the Low Power Mode	29
Figure 9: AT-PWR100R AC Power Supply	33
Figure 10: AT-PWR250 AC Power Supply	33
Figure 11: AT-PWR250R DC Power Supply	33
Figure 12: Stacking Transceivers	38
Figure 13: Stack of Two Switches in the Linear Topology	40
Figure 14: Stack of Four Switches in the Linear Topology	41
Figure 15: Stack of Two Switches in the Ring Topology	42
Figure 16: Stack of Four Switches in the Ring Topology	43
Figure 17: PORT Parameter in the Command Line Interface	46
Figure 18: Components of the switch	55
Figure 19: Power Cord Retaining Clip	58
Figure 20: Inserting the Retaining Clip into the Retaining Bracket	58
Figure 21: Removing the rear panel	60
Figure 22: Installing the AT-PWR100R AC Power Supply Module	61
Figure 23: Securing the AT-PWR100R Power Supply Module	61
Figure 24: Installing the Blank Panel on the Power Supply Slot	62
Figure 25: Turning the Switch Upside Down	64
Figure 26: Removing the Rubber Feet	64
Figure 27: Attaching the Equipment Rack Brackets	65
Figure 28: Mounting the Switch Horizontally in an Equipment Rack	66
Figure 29: Mounting the Switch Vertically in an Equipment Rack	66
Figure 30: Power Cord Retaining Clip in the Up Position	67
Figure 31: Connecting the AC Power Cord	67
Figure 32: DC Terminal Block on the DC AT-PWR250R-80 Power Supply Module	70
Figure 33: Stripped Wire	71
Figure 34: Inserting Wires into a DC Terminal Block	71
Figure 35: Connecting the Management Cable to the Console Port	73
Figure 36: Switch Initialization Messages	74
Figure 37: Switch Initialization Messages (Continued)	75
Figure 38: Switch Initialization Messages (Continued)	76
Figure 39: User Exec Mode Prompt	78
Figure 40: SHOW STACK Command	79
Figure 41: Moving to the Global Configuration Mode	79
Figure 42: Confirmation Prompt for the NO STACK ENABLE Command	80
Figure 43: Returning to the Privileged Exec Mode	80
Figure 44: Saving the Changes with the WRITE Command	80
Figure 45: Status of a Stacking Slot When VCStack is Disabled	81
Figure 46: Status of a Stacking Slot When VCStack is Enabled	82
Figure 47: PORT Parameter in the Command Line Interface	83
Figure 48: User Exec Mode Prompt	87
Figure 49: Moving to the Privileged Exec Mode with the ENABLE Command	87

7