AT&T 518-455-317 manual Touch-Tone Enable F08, Related Procedures

Touch-Tone Enable (F08)

Description

This feature lets a system phone user send touch-tone signals on an outside call over a rotary line. For example, a user may need to dial touch-tone digits while on a call to a bank-by-phone service.

Related Procedures

■You must use Dial Mode (#201) to identify rotary lines to the system.

■To activate this feature from within a number stored on an Auto Dial button or as part of a Speed Dial number, press [ Transfer ] when storing the number—see Special Dialing Functions.

Considerations

■This feature is needed only when dialing on a rotary line.

■Use Touch-Tone Enable only after a call is connected. For example, use this feature after dialing a bank-by-phone service that requires you to dial touch-tone digits.

■You can program a Touch-Tone Enable button on a system phone to turn on Touch-Tone Enable with one touch.

■This feature is available only on system phones.

Programming

To program a Touch-Tone Enable button:

1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ Central Tel Program ].

2.Enter the number of the extension to be programmed with this feature.

3.Press a programmable button.

4.Press [ Feature ] [ 0 ] [ 8 ].

5.Program another button for this extension or exit programming mode.

Using

From a system phone, press the programmed button or press [ Feature ] [ 0 ] [ 8 ] when you need to dial touch-tone digits.

Touch-Tone Enable stays in effect until you hang up.

Touch-Tone Enable (F08) 5-145