Brother FAX 3750, FAX 2750 manual Remote Commands, Operation Details

R E M O T E F A X O P T I O N S 75

Remote Commands

Follow the commands below to access features remotely. When you call the fax machine and enter your Remote Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote control command.

Remote Control Commands				Operation Details
95		Changing Fax Forwarding
		/Paging setting
		1	OFF	If you hear one long beep, the change is accepted. If
				you hear three short beeps, you cannot change it
		2	Fax Forwarding
				because the conditions have not been met (Example:
		3	Paging
				registering paging number). You can register your fax
		4	FAX FWD No.
				forwarding number by using 4. FAX FWD NO (see
		6	Fax Storage ON	page 71). Once you have registered the number, the
				fax machine will change automatically to
	7		Fax Storage OFF
				FAXFWD:ON mode. Then retrieve a Memory Status
				List by entering 961 (see page 76) to make sure that
				the Fax Forwarding number you registered is correct
				in the List.
				You can set FAX STORAGE ON or OFF.
96		Retrieve FAX
		1	Memory Status List	Enter the number of a remote fax machine to receive
		2	Retrieve all faxes	the Memory Status List or stored fax message(s). (See
				page 76.)
		3	Erase fax from the	If you hear one long beep, you can erase fax
			memory	message(s) from the memory.
97 Check the receiving status
	1		FAX	You can check whether your fax machine has received
				any fax message(s). If yes, you will hear one long
				beep. If no, you will hear three short beeps.
98		Change Answer Mode
		1	TAD	If you hear one long beep, you can change the Answer
		2	FAX/TEL	Mode. If you hear three short beeps, you cannot
				change it.
		3	FAX
90		Exit		After a long beep, you can exit remote control.