5. ADJUSTMENT

５-１６. Changing the work clamp lift (KE-435B, 435C, 436B, 436C)

Standard lift amount of the work clamp (1) is 3 mm (max. 8 mm).

3 - 5mm

Increase

Decrease

0.5 - 1mm

2626Q

2483Q

2627Q

Adjusting work clamp lift to 3 - 5 mm

1.Loosen the screw (2) and open the stepping cover (3).

2.Loosen the nut (4) and adjust the stepping work clamp connecting rod (5) position.

*If you would like to increase the work clamp lift, move the stepping work clamp connecting rod (5) up, and if you would like to decrease it, move the stepping work clamp connecting rod (5) down.

Adjusting work clamp lift to 5 - 8 mm

1.Loosen the screw (2) and open the stepping cover (3).

2.Loosen the nut (4) and adjust the stepping work clamp connecting rod (5) position.

*If you would like to increase the work clamp lift, move the stepping work clamp connecting rod (5) up, and if you would like to decrease it, move the stepping work clamp connecting rod (5) down.

3.Remove the face plate and turn the pulley by hand to set the work clamp to its lowest point. Loosen the bolt (9) of stepping work clamp arm R (8). Adjust the clearance between the presser bar lifter (6) and the presser bar bush (7) to 0.5 - 1 mm.

<If vertical movement of the work clamp is not required>

1. Remove the face plate (1).

2. Remove the shoulder screw (2) and re-attach the stepping link assembly (3) to the upper screw hole (a) of the stepping work clamp arm F (13).

3455Q

3456Q

KE-430B, 430C series

110