4. ASSEMBLY

４-１６. Work clamp arm mechanism (KE-432B, 432C)

Be careful not to drop these two ball bearings when installing the feed bracket assembly.

Align with the screw stop and push down from above while tightening the set screw.

Tack length feed slide block

3426Q

Place the tack length feed slide block into the groove of the feed bracket assembly, and then use the screws to install it together with the feed bracket guide plate.

First place onto A, then insert into B and place onto C.

Refer to “4-20. Work clamp arm mechanism (Applying grease)”

 

 

1. Feed bracket assy

 

 

2. Feed bracket guide plate

 

 

3. Screws [8 pcs]

 

 

4. Rod end

 

 

5. Tack width feed shaft

 

 

6. Set screw

 

 

7. Rubber cap

 

 

8. Feed plate

 

 

9. Screws [2 pcs]

 

 

10.

Work clamp felt

 

 

11. Button clamp holder

 

 

 

support

 

 

12.

Plain washers [2 pcs]

 

 

13.

Bolts [2 pcs]

 

 

14.

Work clamp arm assy

 

 

15.

Button clamp holder shaft

 

 

16.

Set screws [2 pcs]

 

 

17.

Nuts [2 pcs]

 

 

 

Adjusting screw

 

 

 

Compression spring

Carry out the adjustment in “5-24. Adjusting the home

 

18. Work clamp carrier rod assy

 

19.

Washer

position” before installing the feed plate.

3428Q

20.

Bolt

 

 

After installing, carry out test feeding and check that the needle hole is inside the work clamp and the feed plate frame. If the needle hole is not inside the frame, adjust the position of the button clamp holder support and feed plate.

KE-430B, 430C series

90