4. ASSEMBLY
Be careful not to drop these two ball | Align with the screw stop and push down | |
from above while tightening the set screw. | ||
bearings when installing the feed bracket | ||
| ||
assembly. |
|
3426Q
Be careful not to drop these three ball bearings when installing the work clamp arm assembly.
Place the tack length feed slide block
Tack length feed into the groove of the feed bracket
slide blockassembly, and then use the screws to install it together with the feed bracket guide plate.
Secure the work clamp arm support shaft with the set screw so that the bottom of the work clamp arm support plate and the ball bearings touch when the work clamp is raised.
Refer to
| 1. Feed bracket assy | |
| 2. Feed bracket guide plate | |
| 3. Screws [8 pcs] | |
| 4. Rod end | |
| 5. Tack width feed shaft | |
| 6. Set screw | |
| 7. Rubber cap | |
| 8. Feed plate | |
| 9. Screws [2 pcs] | |
| 10. | Work clamp felt |
| 11. | Work clamp arm assy |
| 12. | Washers [2 pcs] |
3427Q | 13. | Bolts [2 pcs] |
| 14. | Work clamp arm support shaft |
Carry out the adjustment in | 15. Set screw | |
home position” before installing the feed plate. |
|
|
After installing, carry out test feeding and check that the needle hole is inside the work clamp and the feed plate frame. If the needle hole is not inside the frame, adjust the position of the work clamp arm assembly and feed plate.
89 |