4. ASSEMBLY

４-１８. Work clamp arm mechanism (KE-434B, 434C, 435B, 435C, 436B, 436C, 484C)

Align with the screw stop and push down gently from above while tightening the set screw.

Y-feed lever

3431Q

1)Turn the Y-feed lever forward as far as it will go.

2)Insert the tack width regulator block assembly and the feed guide slide block into the grove in feed bracket guide plate R so that they face as shown in the illustration, and then install the feed bracket assembly and feed bracket guide plate R.

Seen from below

Tack width regulator

 

block assy

 

Y-feed lever

 

cover

1. Feed bracket assy

 

Feed guide

slide block

 

 

3432Q

 

 

2. Feed bracket guide plate, R

 

 

 

 

 

3. Flat screws [2 pcs]

3) Pass the Y-feed lever cover through the slot in the arm bed, and then

4. Screws [2 pcs]

insert the tack width regulator block assembly into the hole in the Y-feed

5. X-feed lever cover

lever.

6.Spacers [2 pcs]

7.Retainer assys [2 pcs]

8.Tack length regulator block assy

9.Set screw

10.Rubber cap

KE-430B, 430C series

92