Brother manual 107

		5. ADJUSTMENT
５-２. Adjusting the needle bar lift amount
3413Q	Needle center line	0135Q

Tip

	<KE-430C series, BE-438C>						<KE-484C>
2464Q								3200Q
	<KE-430B series, BE-438B>
			Support		Felt			Wick
								Felt
		Felt		holder
						When returning the felt support, place it as shown in
	Turn the support in the
						the illustration so as not to clamp the felt, and then
	direction of the arrow, and					gently press the felt and the wick.
	remove the felt holder.		3451Q				3420Q	3421Q

<When using a DP x 17 needle>

Turn the machine pulley to raise the needle bar from the lowest position until the lowest reference line on the needle (reference line B) is aligned with the lower edge of the needle bar bush (1). Then loosen the screw (2) and move the driver (3) to adjust so that the tip of the rotary hook is aligned with the needle center line.

<KE-484C>

Turn the machine pulley to raise the needle bar from the lowest position until the lowest reference line on the needle (reference line B) is aligned with the lower edge of the needle bar bush (1). Then loosen the set screw (2) and move the rotary hook to adjust so that the tip of the rotary hook is aligned with the needle center line.

<When using a DP x 5 or TQ X1 needle>

Turn the machine pulley to raise the needle bar from the lowest position until the second reference line from the top of the needle (reference line B) is aligned with the lower edge of the needle bar bush (1). Then loosen the screw (2) and move the driver (3) to adjust so that the tip of the rotary hook is aligned with the needle center line.

KE-430B, 430C series 100