8. ELECTRIC MECHANISM
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before opening the face plate of the control box. Touching areas where high voltages are present can result in severe injury.
| All DIP switches are set to OFF at the time of | |
| shipment. | |
| Note: | |
| When opening the cover, hold it securely | |
3616Q | so that it does not fall down. | |
| ||
|
| |
|
| |
Switch | Motion when set to ON | |
|
| |
First two stitches are sewn at a low speed of 260 rpm. | ||
|
| |
Last two stitches are sewn at a low speed of 260 rpm. | ||
|
| |
- | ||
|
| |
Last two stitches are sewn at a low speed of 700 rpm. | ||
|
| |
First two stitches are sewn at a low speed of 400 rpm. | ||
|
| |
Low speed sewing is not performed at the start of sewing. | ||
|
| |
The motor operates in reverse when the upper shaft stops, to return the needle | ||
bar to close to its highest position. *NOTE | ||
| ||
| Maximum area for the sewing data is increased. | |
| During an emergency stop, the thread is trimmed and the needle bar stops in the | |
| raised position. |
*Note:
When the motor operates in reverse to raise the needle, the thread
149 |