4. ASSEMBLY
Feed cams X and Y both have index marks. Check these when using.
Assembly steps of the feed mechanism are the same for X and Y directions.
Tighten the set screw in the illustration at the screw stop position.
Set screw at screw stop
3358Q
3359Q
Check that the feed cam turns smoothly.
Place coupling hub 8 onto the cam shaft so that there is no play in the hub, and then tighten the set screw at the screw stop position as shown in the illustration.
Screw stop
3360Q
3361Q
1.Feed cam
2.Ball bearings [2 pcs]
Place the coupling hub onto the pulse motor shaft, and then tighten the set screw at the screw stop position so that the pulse motor shaft protrudes from the edge by 2.5 mm.
3362Q |
| 3. Cam shaft (with retaining ring) | ||
| ||||
| 4. Coupling hub, | 8 | ||
|
|
| ||
|
|
| 5. Set screws [2 pcs] | |
|
|
| 6. Set screws [2 pcs] | |
|
|
| 7. Feed home position dog | |
|
|
| 8. Screw [Provisionally tighten at | |
|
|
| middle of slot] |
|
|
|
| 9. Coupling hub, | 6.35 |
|
|
| Coupling hub, | |
|
|
| 10. Set screws [2 pcs] | |
|
|
| ||
|
|
|
|
|
70 |