4. ASSEMBLY

3332Q

KE-484C

Install the retaining ring between the thread driving lever assembly and the washer.

3331Q

Place the cushion against the edge of the arm, set the various parts so that there is no gap between them as shown in the illustration, and then tighten the set screw as far as the screw stop.

Adjust the position of the thread driving lever assembly while referring to “5-20. Adjusting the position of the thread trimming link mechanism”.

Tighten the set screw on the screw flat while lightly pressing the lever shaft downward.

Apply grease.

Apply grease.

Apply grease.

Tilt the machine head.

Apply grease.

Tighten the set screw on the screw flat while lightly pressing the thread trimmer lever shaft upward.

3333Q

1.Driving lever guide shaft

2.Spring

3.Washer

4.Thread driving lever assy

5.Cushion

6.Retaining rings [2 pcs]

7.Set screw

8.Rubber cap

9.Thread trimmer rod, L

10.Lever shaft

11.Set screw

12.Rubber cap

13.Thread trimmer lever

14.Thread trimmer lever shaft (with washer and retaining ring)

15.Set screw

16.Thread trimmer rod assy

17.Shoulder screw

18.Nut

19.Washers [2 pcs]

20.Shoulder screw

21.Nut

22.Thread trimmer cylinder

23.Bolts [2 pcs]

24.Spring

55

KE-430B, 430C series