4. ASSEMBLY

KE-434B, 435B, 436B

KE-434C, 435C, 436C, 484C

Push the home position sensor Y cable into the recess.

Oil supply hole

Note:

Home position dog, X

Home position sensor X

3379Q

Install the X-sensor setting base so that there is a gap of 0.5–0.9 mm between the sensing surface of home position sensor X and the home position dog X.

3378Q

3377Q

Make sure the wick does not touch the connecting rod lever.

1)Insert the tack width feed lever shaft with the thrust washer and retaining ring installed into the Y-feed lever assembly, press down on the top of it so that there is no play, and then tighten the set screw at the screw stop position.

*Check that the Y-feed lever assembly moves smoothly.

1. X-feed lever assy [Insert onto bushing]

2. Feed cam roller

3575Q

3376Q

2) Put the driver into the end of the Y-feed lever, and press the X-feed lever assy downward.

3) Place the set screw collar on the shaft of the X-feed lever, press it in the direction of the arrow, and tighten the set screws.

[Place into groove of feed cam X]

3. Thrust washer

4. Y-feed lever assy

5. Feed cam roller

[Place into groove of feed cam Y]

6. Thrust washer

7. Tack width feed lever shaft (with retaining

ring)

8. Set screw

9. Set screw collar

10.

Set screws [2 pcs]

11.

X-sensor setting base

12.

Screw

13.

Y-sensor setting plate

14.

Screw

15.

Cord clamps [3 pcs]

16.

Screws [3 pcs]

17.

Wick [Insert into oil supply hole]

18.

Wick [Insert into oil supply hole]

75

KE-430B, 430C series