Brother manual 163

	8. ELECTRIC MECHANISM
Memory switches (00–0F)
Switch No.	Motion when set to ON		Initial value
memo-00	When moving to the home position, the feed plate moves in the order θ → r and the start		−
	position moves in the order r → θ. (*1)
	(The feed plate does not move via the position that has been set by memo-3C.)
memo-01	When moving to the home position, the feed plate moves in the order r → θ and the start		−
	position moves in the order θ → r. (*1)
	(The feed plate does not move via the position that has been set by memo-3C.)
memo-02	−		−
memo-03	−		−
memo-04	Needle stops in up position during emergency stop. (Needle normally stops in	down	−
	position.)
memo-05	When sewing is finished, the feed plate moves via the machine home position to the start		−
	position.
memo-06	After the final stitch, the work clamp rises and then the feed plate returns to the	start	−
	position.
memo-07	Intermittent work clamp is not used (does not rise).		−
memo-08	When using an inner clamping device, the inner clamping device moves forward at the		−
	1/4-way mark and returns at the 3/4-way mark for the pattern being sewn. (Inner clamping
	device is available as an option.)
memo-09	Changes the wiper to air drive. (Air wiper is available as an option.)		−
memo-0A	Jog feeding becomes faster during programming.		−
memo-0b	ON when a two-stage tensioner is used (available as an option).		−
memo-0c	−		−
memo-0d	Clearing the emergency stop switch action is carried out using the STEP BACK switch.		ON
	Note: The factory default setting is ON, and it changes to ON when all memory settings are
	cleared.
memo-0E	Test feeding is carried out at the same speed as normal sewing. (For checking	feed	−
	operation)
memo-0F	After sewing is finished, the work clamp automatically opens and closes once. (practice		−
	operation)
	If memo-0E is ON, the work clamp opens and closes twice.

*1: The θ direction is rotation with reference to the x axis, and the r direction is rotation with reference to the y axis.

Memory switches (10–1F)

Switch No.	Motion when set to ON	Initial value
memo-10	−	−
memo-11	Bobbin thread counter and production counter are adjusted when thread is trimmed.	−
memo-12	−	−
memo-13	−	−
memo-14	Needle up error detected.	−
memo-15	When using the inner clamping device, shunting to prevent interference between the inner	−
	clamping device and the needle is not carried out after the sewing end. (Inner clamping
	device is available as an option.)
memo-16	−	−
memo-17	−	−
memo-18	−	−
memo-19	−	−
memo-1A	−	−
memo-1b	−	−
memo-1c	Bobbin thread counter is decremented at the start of sewing.	−
memo-1d	When using an air pressure drop detection switch. (This detection switch is available by	−
	special order.)
memo-1E	Changes the split number automatically by using an external switch. (Use option connector	−
	P3 on the operation panel.)
memo-1F	Program number is changed automatically by using outside switch. (Use optional	−
	connector P3 on the operation panel.)

KE-430B, 430C series 156