Cabletron Systems Ethernet Hubs manual

Changing MIM Representations

Changing MIM Representations on a Single Module Using the Mouse

NOTE

This procedure works only when you are viewing the Physical representation of modules and you want to change to a Logical representation.

Changing MIM Representations on a Single Module Using the Mouse

To change the MIM representation of a single module using the mouse, follow these steps:

1.From the Physical representation of the Device View, move the mouse pointer onto the module.

NOTE

Make sure that the mouse pointer is not on top of, or next to, a gauge or port connector (depending on the initial MIM presentation) otherwise a Port Performance View will open.

2.Double-click the left mouse button. The appearance of the selected module changes. A selected single module appears to extend from the hub chassis.

3.Double-click the left mouse button again to return the module to its original appearance.

NOTE

This procedure works only when you are viewing the Physical representation of modules and you want to change to a Logical representation.

Device Views	Cabletron Ethernet Hubs
2-24	Management Module Guide