Configuration View Description

Configure Alarms View

Factory Defaults

This button allows you to reset the device’s settings to their factory defaults. This button is only available in the IRM2 and IRM3 Control Views. (Does not affect IP address)

Configure Alarms View

You can access this view by clicking on the Config Alarms button in the Configuration View. This view allows you to set threshold alarms and enable them. The Configure Alarms View is not available for the IRM hub. This view contains the following information:

Model Name

The user-defined or default name of the model.

Device Name

The ASCII name of the device read from the device firmware.

Network Address

The network IP address (e.g., 132.177.118.24).

Traffic Alarms

This button allows you to Enable or Disable detection of Traffic Alarms.

Traffic Threshold

The threshold value within the alarm timebase which, once that number of packets is exceeded, generates a traffic alarm.

Collision Alarms

This button allows you to Enable or Disable detection of device-level Collision Alarms.

Collision Threshold

The threshold value within the alarm timebase which, once that number of collisions per good packet is exceeded, generates a collision alarm. Possible values range from 1 to 15.

Error Alarms

This button allows you to Enable or Disable detection of Error Alarms. This button is not available in the MRXI Configure Alarms View.

9030367 E7

Configuration Views

 

4-9

Page 66
Image 66
Cabletron Systems Ethernet Hubs manual Configure Alarms View