Specifying Destinations

Specifying Destinations

This section describes how to specify a fax destination. You can select a destination stored in the Address Book, a one-touch key or coded dial code, or you can specify a new destination.

Using Numeric Keys

You can specify a new fax number using – , [numeric keys] and[Tone].

1

Place documents.

2

Press

[SEND/FAX]/

[FAX].

3

Press

[SEND/FAX] repeatedly to

select <FAX>, then press [OK].

 

F A X

S E L E C T : O K

For the D1150, skip this step.

4

Use – , [numeric keys] and

[Tone] to enter the fax number.

Ex.

F A X N U M B E R

T E L = 0 1 2 X X X X X X X

If you entered a wrong number when specifying a fax number, go back to the wrong digit with .

If <CONFIRM FAX NO.> in <ACCESS TO DEST.> in <SYSTEM SETTINGS> is set to <ON> and you specify a fax number using – , [numeric keys] and [Tone], you need to enter the fax number again for confirmation. Enter the same fax number you entered in step 4, then press [OK].

5

Press [Start].

 

 

– When you place the documents on the platen

 

glass, press

or

to select the document

 

size, then press

 

[Start] for each document.

When scanning is complete, press [OK] to start sending.

– You can also adjust the following scan settings as necessary, using the keys on the operation panel, after specifying the destination in step 4.

• Density: See “Adjusting Density,” on p. 6-29.

• Image Quality: See “Selecting Image Quality,” on p. 6-30.

• 2-Sided: See “2-Sided Documents,” on p. 6- 31.

(D1180/D1170/D1150) Fax

6-19