Cannot Print Properly from the Digital Camera

The following are the possible errors that may occur when printing directly from a digital still camera or digital video camcorder*, and the countermeasures to eliminate them.

*Hereafter, the digital still camera and digital video camcorder are collectively called a digital camera or camera.

Note

zPictBridge or Canon Bubble Jet Direct compatible digital cameras can be connected to your machine for direct printing.

zThis section describes errors that are indicated on Canon-brand PictBridge- or Bubble Jet Direct compatible cameras. The error messages and operations may vary depending on the camera you are using. If you are using a non-Canon PictBridge compatible camera and not sure how to clear the printer error from the camera, confirm the message displayed on the LCD of the machine and clear the error. For clearing an error from the machine, see “An Error Message is Displayed on the LCD” on page 161.

zA communication time out occurs if printing takes a long time or if it takes too much time to send data. This may stop printing. In such cases, disconnect the cable between the machine and the camera, and reconnect the cable between the machine and the camera. Then, turn the camera on, if it does not automatically turn on. If the problem is still unresolved, select some other photo and check if it can be printed or not.

zSome PictBridge compatible devices may need to be switched to printing mode before connecting them to the machine. Also, it may need to be turned on manually or switched to replay mode after connected to the machine. Refer to the instruction manuals supplied with your PictBridge compatible device and take the necessary steps before connection.

zThe Print Head nozzles may be clogged if printing becomes faint or colors are incorrect. See “When Printing Becomes Faint or Colors are Incorrect” on page 148.

zIf the paper is curled or its surface is scratched during printing, make sure that you are using the correct type of paper. If this error occurs even when you are using the correct type of paper, see “If printing surface abrasion is not resolved even after taking the actions above:” on page 173.

zFor the errors indicated on the camera and their solution, also refer to the user’s manual of the camera. For other troubles with a digital camera, contact the manufacturer of the camera.

Error Message On Camera

Action

Printer in use/Printer warming up

Photos are printed from the computer.

 

Wait until printing ends. When it is ready, the machine starts printing

 

automatically.

 

 

No paper/Media Type error/Paper

z Load paper in either the Auto Sheet Feeder or Cassette which you have

Error

selected with [Feed Switch] on the machine, and select “Continue”*1 in

 

the display on your camera.

 

z The camera does not support the page size that is selected on this

 

machine. Check the print settings and select the page size that is

 

supported by the camera.

 

z Open the Paper Output Tray to resume printing. Close the Inner Cover if

 

it is open. Select “Stop” in the display on your camera to stop printing.

 

 

Paper jam

Select “Stop” in the display on your camera to stop printing.

 

Remove the jammed paper, load new paper, and press [OK] on the machine

 

and retry printing.

 

 

Printer cover open

Close the Scanning Unit (Printer Cover) on the machine.

 

 

Chapter 11

Troubleshooting

179