Setting the Power Save Mode
The machine enters Power save mode if not operated for a certain interval. In the Power save mode, the internal fluorescent lamp are turned off, and the selected Mode Lamp stays lit. You can configure the interval that the machine waits before entering Power save mode. See “Power save setting” on page 141.
When you try to perform any operation such as copying, faxing, or scanning, the machine will exit from Power save mode.
If you use the machine frequently, we recommend that you set the Power save transfer time to 1 hour or 8 hours.
The
The LCD goes out if the machine is not operated for 5 minutes. Press any button to restore the display. You cannot change the period before the LCD goes out.
Loading Documents to Copy, Fax, or Scan
This section describes how to load the document.
Document Requirements
The documents you load on the Platen Glass or the ADF for copying, faxing, or scanning must meet these requirements:
| Platen Glass | ADF |
|
|
|
Document | z Documents | Multipage documents of the same size, |
type | z Photographs | thickness, and weight |
| ||
| z Book |
|
| z Documents that are not suitable for the |
|
| ADF |
|
|
|
|
Size (W x L) | Max. 8.5" x 11.7" / 216 x 297 mm | Max. 8.5" x 14.0" (216 x 356 mm) |
|
| Min. 5.8" x 5.8" (148 x 148 mm) |
|
| Only A4- or |
|
| sided copying or scanning |
|
|
|
Quantity | 1 sheet | z Max. 35 pages of A4- or |
|
| sheets (20 lb. or 75 g/m2 paper), up to |
|
| 5 mm in height |
|
| z Max. 30 pages of |
|
| (20 lb. or 75 g/m2 paper), up to 4 mm in |
|
| height |
|
| z 1 sheet for sizes other than these |
|
|
|
Thickness | Max. 0.8" / 20 mm | 0.002" to 0.005" (0.06 to 0.13 mm) |
|
|
|
Weight | — | 13 to 24 lb. (50 to 90 g/m2) |
|
|
|
Chapter 1 | Before Printing | 19 |