(A)
(3)
(1)
(2)
Important
Do not load the paper beyond this Load Limit Mark (A).
Note
zYou can use general copy paper or Canon’s Super White Paper
zYou can load up to 150 sheets of plain paper (64 gsm or 17 lb, 13 mm or 0.52 inches in height) in the Auto Sheet Feeder. However, the paper may not be fed normally depending on its media type or your environment where the temperature and humidity are high or low. In that case, reduce the amount of paper to half (approx. 0.2" / 5 mm in height).
zRemove the printed sheets from the Paper Output Tray before the count reaches 50.
zDo not touch the printed surfaces until the ink dries. For specific drying times, refer to the instructions packaged with your media.
zLoading Envelopes
Use either European DL or US Comm. Env. #10 size envelopes.
Important
zEnvelopes can be used only when printing from a computer.
zDo not use envelopes with embossed or treated surfaces, a double flap, pressure seals or sticker flaps.
zSelect either [DL Env.] or [Comm. Env. #10] according to the envelope size you are using.
zThe printed image will be upside down depending on the application. If this occurs, open the printer properties dialog box then select the [Rotate 180 degrees] check box on the [Page Setup] tab.
For information on the printer driver settings, refer to the Printer Driver Guide.
1 Load the envelope against the Cover Guide on the right side of the Paper Support with the print side facing UP, and the rear flaps DOWN on the left.
Important
Ensure that the Cover Guide stands when you load paper in the Auto Sheet Feeder.
Chapter 1 | Before Printing | 29 |