Chapter 3 Installing the Cisco Wide Area Application Engine
Connecting Power and Booting the System
Figure |
| |||||
| 1 | 2 | 3 |
| 4 |
|
|
|
|
|
|
| 115773 |
|
|
| 8 | 7 | 5 |
|
|
|
|
|
| 6 |
|
1 | AC power receptacle |
| 5 | Ethernet 2 receptacle | ||
2 | Mouse connector |
|
| 6 | USB ports (not supported) | |
3 | Keyboard connector |
| 7 | Video connector | ||
4 | Ethernet 1 receptacle |
| 8 | Serial connector | ||
Note Cisco WAFS and ACNS software do not support the use of a keyboard or mouse (PS/2 or USB). However, a keyboard and mouse are supported by the BIOS for
Connecting Power and Booting the System
To connect power to the device, follow these steps:
Step 1 Review the information in the “Safety Warnings” section on page 2-1.
Step 2 Plug the AC power cord into the power cord receptacle at the rear of the device. (See Figure
Step 3 Connect the other end of the power cord to a power source at your installation site. Step 4 Power up all externally connected devices.
| Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide |
|
