Cisco Systems 611 manual Specification Description

Appendix A Technical Specifications

Appliance Specifications

Table A-1		Appliance Features and Specifications
Specification			Description
Microprocessor			• WAE-511—One Intel 2.8-GHz Celeron 256-KB with level 2 cache and
			multimedia extensions (MMX2) technology
			• WAE-611—One Intel 3.0-GHz Pentium 4800 MHz with level 2 cache
			and multimedia extensions (MMX2) technology
Memory			• WAE-511—One or two 512-MB SDRAM DIMMs
			(MEM-WAE-512MB=)
			• WAE-611—Two 1-GB SDRAM DIMMs (fixed configuration)
			Regardless of the the amount of memory installed on your hardware device,
			the amount of memory supported is regulated by the software version that
			is installed:
			• WAFS software supports up to 1 GB of memory.
			• ACNS software supports up to 512 MB of memory. ACNS software
			does not support additional memory over 512 MB.
Expansion bays			Two 3.5-in. (8.89-cm) slim-height bays for hard disk drives
Expansion slots			Two 66-/100-MHz 64-bit PCI-X slots on the system board (half-length
			full-height slots; one low profile and one full profile)
Hard disk controller			• WAE-511—Serial advanced technology attachment (SATA) controller
			• WAE-611—Ultra320 SCSI controller
Adapters			• 1-port Fibre Channel adapter
			• 1-port MPEG A/V decoder adapter
			Note The WAE-511 and WAE-611 support either the Fibre Channel
			adapter or the MPEG A/V decoder adapter in PCI slot 1.
			• Ultra320 SCSI adapter installed in PCI slot 2 (WAE-611 only)
			• 4-port Ethernet inline network adapter
Power supply			1 AC-input
Dimensions			• Height: 1.75 in., 1 RU (44 mm)
			• Depth: 20 in. (508 mm)
			• Width: 16.94 in. (430 mm)
	Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
A-2			OL-7220-02