Chapter 4 Installing Hardware Options
Removing the Cover and Bezel
Step 3 Loosen the two captive screws (1) on the rear of the cover. (See Figure
Figure 4-1 Removing the Cover
1
115802
Step 4 Slide the cover back; then lift it up and off the device.
Caution For proper cooling and airflow, replace the cover before turning on the device. Operating the device for extended periods (over 30 minutes) with the cover removed might damage device components.
Step 5 Remove the bezel as shown in Figure
a.Press the release tabs on the bezel and pull the bezel away from the chassis.
b.Store the bezel in a safe place.
| Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide |
|
