Chapter 3 Installing the Cisco Wide Area Application Engine
Checking the LEDs
Step 5 Press the power control button on the front of the device.
The system should begin booting. Once the operating system boots, you are ready to initialize the basic software configuration. (See the “Related Documentation” section on page xiii for a list of software configuration documents.)
Note While the device is powering up, the power LED on the front of the chassis is green.
Note You can install a circular disk over the power control button to prevent accidental manual power down. This disk, known as the power control button shield, comes with the device.
Checking the LEDs
When the device is up and running, observe the front panel LEDs. To verify that your system is operating properly, see the “LED Indicators” section on page
Removing or Replacing a Cisco Wide Area Application Engine
Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord. Statement 1
Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040
To remove a device from your network, power it down, disconnect the power cords and network cables, and physically remove the chassis from the rack.
|
| Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide |
|
|
|
|
| ||
|
|
|
| |
|
|
|
