Cisco Systems 611 manual Installing Hardware Options, Removing the Cover and Bezel

C H A P T E R4

Installing Hardware Options

This chapter provides basic instructions for installing hardware options in the Wide Area Application Engine (WAE). These instructions are intended for experienced technicians.

This chapter contains the following topics:

•Removing the Cover and Bezel, page 4-1

•Installing Adapters, page 4-3

•Installing DIMMs, page 4-12

•Working with Hard Disk Drives, page 4-15

•Completing the Installation, page 4-17

Removing the Cover and Bezel

Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord. Statement 1

To remove the cover, follow these steps:

Step 1 Review the information in the “Safety Warnings” section on page 2-1, and the “Safety Guidelines” section on page 2-4.

Step 2 Power down the device and all attached devices. Disconnect the power cord and all external cables.

	Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02		4-1