Cisco Systems 611 Tools and Parts Required, Installing the Cisco Wide Area Application Engine

Chapter 3 Installing the Cisco Wide Area Application Engine

Tools and Parts Required

Tools and Parts Required

A sliding rail rack-mount kit and cable management assembly is included in your shipping container accessory box. The rack-mount kit is suitable for mounting the device in a 19-inch (48.26-cm) four-post equipment rack.

Angle brackets for mounting the device in a two-post rack are also included in your shipping container.

You need the following parts and tools to install the device in a rack:

•Flat-blade screwdriver

•Phillips screwdriver

•One rack-mount kit

•Documentation

Installing the Cisco Wide Area Application Engine

Place the device in the desired location. You can mount it in a rack for your convenience, or place it on a solid, stable surface. If you do not plan to install the unit in an equipment rack, proceed to the “Installing the Chassis on a Tabletop” section on page 3-12.

Racks are marked in vertical increments of 1.75 inches (4.44 cm). Each increment is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.

	Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
3-2	OL-7220-02