
Chapter 4 Installing Hardware Options
Completing the Installation
To install the cover and bezel, follow these steps:
Step 1 Install the cover by placing it into position and sliding it forward, and then tighten the captive screws (labeled 1 in Figure
Caution Before sliding the cover forward, make sure that the cover will properly engage the ledge at the front of the device.
Step 2 Install the bezel:
a.Align the hooks on the bottom of the bezel with the device.
b.Press the bezel toward the device until it clicks into place.
Figure 4-8 Installing the Cover
1
115802
| Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide |
|