Cisco Systems AS5350XM Connecting to a WAN, Connecting to an Ethernet Hub 10/100BASE-T Shown

Chapter 3 Installing the Cisco AS5350XM Universal Gateway

Connecting to the Network

Caution To comply with the intra-building lightning surge requirements of GR-1089-CORE, Issue III, October 2002, you must use a shielded cable when connecting to either of the Cisco AS5350XM universal gateway Ethernet ports. The cable must consist of shielded cable terminated by shielded connectors on both ends, with the cable shield material tied to both connectors.

Figure 3-6 Connecting to an Ethernet Hub (10/100BASE-T Shown)

1

2

122115

8 7

1

3

1 GE1 10/100/1000BASE-T port 2 Ethernet hub

3Straight-through Ethernet cable

Connecting to a WAN

Warning The telecommunications lines must be disconnected 1) before unplugging the main power connector and/or 2) while the housing is open. Statement 89

Warning Hazardous network voltages are present in WAN ports regardless of whether power to the router is OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables, detach the end away from the router first. Statement 77

Warning This equipment is to be installed and maintained by service personnel only as defined by AS/NZS 3260 Clause 1.2.14.3 Service Personnel. Statement 88

Warning To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement 1023

You can connect the Cisco AS5350XM universal gateway to a WAN in the following ways:

•Connect each T1/PRI port to an RJ-45 jack with a straight-through RJ-45 to RJ-45 cable. (See Figure 3-7and Figure 3-8.)

Cisco AS5350XM Universal Gateway Chassis Installation Guide

OL-6417-02 3-7