Chapter 2 Preparing to Install the Cisco AS5350XM Universal Gateway
Preparing to Connect to a Network
Auxiliary Port
The Cisco AS5350XM universal gateway includes an
For detailed information about connecting devices to the auxiliary port, see Chapter 3, “Installing the Cisco AS5350XM Universal Gateway.” See Appendix C, “Cabling Specifications,” for cable and port pinouts.
2T Serial Ports
Two
The following types of serial interface standards (in DTE or DCE devices) are supported:
•
•
•
•
•
•
Each interface supports up to 8 Mbps.
Alarm Port
The three pins on the alarm port are connected to the output of a relay. This relay is controlled by system software. To configure the alarm port, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide. This document is available on Cisco.com. (See the “Obtaining Documentation” section on page xiv.)
With the alarm port connected and configured, Cisco IOS software polls the universal gateway every one second to detect the failure events that occur and turns on the alarm when it detects any failure event. See Appendix C, “Cabling Specifications,” for pinouts and cable specifications.
BITS Port
The BITS port is a coaxial interface that provides external synchronized clocking through a timing signal generator (TSG). To configure the BITS port, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide. This document is available on Cisco.com. (See the “Obtaining Documentation” section on page xiv.) See Appendix C, “Cabling Specifications,” for pinouts and cable specifications.
Cisco AS5350XM Universal Gateway Chassis Installation Guide
|
| ||
|
|
