Cisco Systems AS5350XM manual 7 Connecting a 2-Port or 4-Port DFC to an RJ-45 T1 Jack, RJ-45 jack

Chapter 3 Installing the Cisco AS5350XM Universal Gateway

Connecting to the Network

Figure 3-7 Connecting a 2-Port or 4-Port DFC to an RJ-45 (T1) Jack

Straight-through

RJ-45-to-RJ-45 cable

RJ-45 jack

35672

Figure 3-8 Connecting an 8-Port DFC to an RJ-45 (T1) Jack

56057

0	1	2 3 4
P P			6 7

T1/E1 8 PRI

connector

Straight-through
RJ-45-to-RJ-45 cable	RJ-45 jack

Note Use software commands to choose a specific port and the line termination on that port. For information about software commands, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide. This document is available on Cisco.com. (See the “Obtaining Documentation” section on page xiv.)

Note If you choose a port with 75-ohm input impedance, use an RJ-45-to-75-ohm coaxial cable adapter and plug it into that port.

Cisco AS5350XM Universal Gateway Chassis Installation Guide

3-8 OL-6417-02