Cisco Systems AS5350XM manual Connecting the AC Power Cord

Chapter 3 Installing the Cisco AS5350XM Universal Gateway

Supplying Power

Note The grounding architecture for the Cisco AS5350XM universal gateway is isolated DC return (DC-I).

Warning Do not touch the power supply when the power cord is connected. For systems with a power switch, line voltages are present within the power supply even when the power switch is off and the power cord is connected. For systems without a power switch, line voltages are present within the power supply when the power cord is connected. Statement 4

Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase conductors (all current-carrying conductors). Statement 13

Warning The device is designed to work with TN power systems. Statement 19

Connecting the AC Power Cord

To connect the power cord, follow these steps:

Note The redundant AC power supply has a non-standard connector. Use the electrical power cord that came with your universal gateway.

Step 1 Connect one end of the AC power cord to the power connector on the rear panel of the Cisco AS5350XM universal gateway (See Figure 3-16or Figure 3-17.)

Step 2 Connect the other end of the AC power cord to the power outlet.

Warning The plug-socket combination must be accessible at all times, because it serves as the main disconnecting device. Statement 1019

Cisco AS5350XM Universal Gateway Chassis Installation Guide

3-14 OL-6417-02