5-6
ASDM configuration guide
Chapter5 Using the Startup Wizard
Startup Wizard Screens
Step4 In the Network Participation area, which you use to have the IPS module participate in SensorBase data
sharing, click Full, Partial, or Off.
Time Zone and Clock Configuration (ASA 5585-X)
Configure the clock parameters. See the “Setting the Date and Time” section on page17-2 for more
information.
Auto Update Server (Single Mode)
•Configure an auto update server by checking the Enable Auto Update Server for ASA check box.
See the “Configuring Auto Update” section on page80-7 for more information.
•If you have an ASA 5585-X with an IPS SSP, you can check the Enable Signature and Engine
Updates from Cisco.com check box. Set the following additional parameters:
–
Enter your Cisco.com username and password, and then confirm the password.
–
Enter the start time in hh:mm:ss format, using a 24-hour clock.
Note For the ASA 5505, to access this screen, you must have checked the Configure the device for
Tele wor ker usa ge check box in Basic Configuration.
Startup Wizard Summary
This screen summarizes all of the configuration settings that you have made for the ASA.
•To change any of the settings in previous screens, click Back.
•Choose one of the following:
–
If you ran the Startup Wizard directly from a browser, when you click Finish, the configuration
settings that you created through the wizard are sent to the ASA and saved in flash memory
automatically.
–
If you ran the Startup Wizard from within ASDM, you must explicitly save the configuration in
flash memory by choosing File > Save Running Configuration to Flash.