30-6
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter30 Configuring EIGRP
Customizing EIGRP
Step12 Click OK.
Customizing EIGRP
This section describes how to customize the EIGRP routing and includes the following topics:
•Defining a Network for an EIGRP Routing Process, page30-6
•Configuring Interfaces for EIGRP, page30-7
•Configuring the Summary Aggregate Addresses on Interfaces, page30-8
•Changing the Interface Delay Value, page30-9
•Enabling EIGRP Authentication on an Interface, page 30-10
•Defining an EIGRP Neighbor, page30-11
•Redistributing Routes Into EIGRP, page30-11
•Filtering Networks in EIGRP, page30-13
•Customizing the EIGRP Hello Interval and Hold Time, page30-14
•Disabling Automatic Route Summarization, page30-15
•Configuring Default Information in EIGRP, page30-15
•Disabling EIGRP Split Horizon, page30-16
•Restarting the EIGRP Process, page30-17

Defining a Network for an EIGRP Routing Process

The Network table lets you specify the networks used by the EIGRP routing process. For an interface to
participate in EIGRP routing, it must fall within the range of addresses defined by the network entries.
For directly connected and static networks to be advertised, they must also fall within the range of the
network entries.
The Network table displays the networks configured for the EIGRP routing process. Each row of the
table displays the network address and associated mask configured for the specified EIGRP routing
process.
To add or define a network, perform the following steps:
Step1 In the main ASDM window, choose Configuration > Device Setup > Routing > EIGRP > Setup.
The EIGRP Setup pane appears.
Step2 Check the Enable EIGRP routing check box.
Step3 In the EIGRP Process field, enter the autonomous system (AS) number for the EIGRP process. The AS
number can be from 1 to 65535.
Step4 Click the Networks tab.
Step5 Click Add to add a new network entry.
The Add EIGRP Network dialog box appears. To remove a network entry, choose the entry in the table
and click Delete.