14-7
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter14 Completing Interface Configuration (Routed Mode)
Completing Interface Configuration in Routed Mode
•If you are using failover, do not use this procedure to name interfaces that you are reserving for
failover and Stateful Failover communications. See the “Configuring Active/Standby Failover”
section on page 66-7 or the “Configuring Active/Active Failover” section on page 67-8 to configure
the failover and state links.
Restrictions
•PPPoE is not supported in multiple context mode.
Prerequisites
•Set up your interfaces depending on your model:
–
ASA 5510 and higher—Chapter12, “Starting Interface Configuration
(ASA 5510 and Higher).”
–
ASA 5505—Chapter13, “Starting Interface Configuration (ASA 5505).”
•In multiple context mode, you can only configure context interfaces that you already assigned to the
context in the system configuration according to the “Configuring Multiple Contexts” section on
page 11-14.
•In multiple context mode, complete this procedure in the context execution space. To change from
the system to a context configuration, in the Configuration > Device List pane, double-click the
context name under the active device IP address.
Detailed Steps
Step1 Choose the Configuration > Device Setup > Interfaces pane.
For the ASA 5505, the Interfaces tab shows by default.
Step2 Choose the interface row, and click Edit.
The Edit Interface dialog box appears with the General tab selected.
Step3 In the Interface Name field, enter a name up to 48 characters in length.