Cisco Systems Configuring Dynamic PAT (Hide)

33-8
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter33 Configuring Network Object NAT (ASA 8.3 and Later)
Configuring Network Object NAT
•Translate DNS replies for rule—Translates the IP address in DNS replies. Be sure DNS inspection
is enabled (it is enabled by default). See the “DNS and NAT” section on page32-24 for more
information.
•(Required for Transparent Firewall Mode) Source Interface—Specifies the real interface where this
NAT rule applies. By default, the rule applies to all interfaces.
•(Required for Transparent Firewall Mode) Destination Interface—Specifies the mapped interface
where this NAT rule applies. By default, the rule applies to all interfaces.
When you are finished, click OK. You return to the Add/Edit Network Object dialog box.
Step9 Click OK, and then Apply.
Configuring Dynamic PAT (Hide)
This section describes how to configure network object NAT for dynamic PAT (hide). For dynamic PAT
using a PAT pool, see the “Configuring Dynamic NAT or Dynamic PAT Using a PAT Pool” section on
page 33-4 instead of using this section. For more information, see the “Dynamic PAT” section on
page 32-10.
Detailed Steps
Step1 Add NAT to a new or existing network object:
•To add a new network object, choose Configuration > Firewall > NAT Rules, then click Add >
Add Network Object NAT Rule.