Cisco Systems Licensing Requirements for Access Rules

37-6
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter37 Configuring Access Rules
Licensing Requirements for Access Rules
•Trunk port (Cisco proprietary) BPDUs. Trunk BPDUs have VLAN information inside the payload,
so the ASA modifies the payload with the outgoing VLAN if you allow BPDUs.
The following types of traffic are not supported:
•802.3-formatted frames—These frames are not handled by the rule because they use a length field
as opposed to a type field.
Access Rules for Returning Traffic
Because EtherTypes are connectionless, you need to apply the rule to both interfaces if you want traffic
to pass in both directions.
Allowing MPLS
If you allow MPLS, ensure that Label Distribution Protocol and Tag Distribution Protocol TCP
connections are established through the ASA by configuring both MPLS routers connected to the ASA
to use the IPaddress on the ASA interface as the router-id for LDP or TDP sessions. (LDP and TDP
allow MPLS routers to negotiate the labels (addresses) used to forward packets.)
On Cisco IOS routers, enter the appropriate command for your protocol, LDP or TDP. The interface is
the interface connected to the ASA.
hostname(config)# mpls ldp router-id interface force
Or
hostname(config)# tag-switching tdp router-id interface force
Licensing Requirements for Access Rules
The following table shows the licensing requirements for this feature:
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported in routed and transparent firewall modes.
IPv6 Guidelines
Supports IPv6.
Model License Requirement
All models Base License.