Cisco Systems Changing the Interface Delay Value

30-9
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter30 Configuring EIGRP
Customizing EIGRP
Step1 In the main ASDM window, choose Configuration > Device Setup > Routing > EIGRP > Interfaces.
The Interface pane shows the EIGRP interface configurations. The Interface Parameters table shows all
of the interfaces on the ASA and lets you modify the settings on a per-interface basis. For more
information about these settings, see the “Configuring Interfaces for EIGRP” section on page30-7.
Step2 To configure the EIGRP parameters for an interface, double-click an interface entry or select the entry
and click Edit.
Step3 Click OK.
Step4 Choose Configuration > Device Setup > Routing > EIGRP > Summary Address.
The Summary Address pane displays a table of the statically-defined EIGRP summary addresses. By
default, EIGRP summarizes subnet routes to the network level. You can create statically defined EIGRP
summary addresses to the subnet level from the Summary Address pane.
Step5 Click Add to add a new EIGRP summary address, or to click Edit to edit an existing EIGRP summary
address in the table.
The Add Summary Address or Edit Summary Address dialog box appears. You can also double-click an
entry in the table to edit that entry.
Step6 In the EIGRP Process field, enter the autonomous system (AS) number for the EIGRP process. The AS
number can be from 1 to 65535.
Step7 In the Interface drop-down list, choose the interface from which the summary address is advertised.
Step8 In the IP Address field, enter the IP address of the summary route.
Step9 In the Netmask field, choose or enter the network mask to apply to the IP address.
Step10 Enter the administrative distance for the route in the Administrative Distance field. If left blank, the route
has the default administrative distance of 5.
Step11 Click OK.
Changing the Interface Delay Value
The interface delay value is used in EIGRP distance calculations. You can modify this value on a
per-interface basis.
To change the interface delay value, perform the following steps:
Step1 In the main ASDM window, choose Configuration > Device Setup > Routing > EIGRP > Interfaces.
The Interface pane shows the EIGRP interface configurations. The Interface Parameters table shows all
of the interfaces on the ASA and lets you modify the settings on a per-interface basis. For more
information about these settings, see the “Configuring Interfaces for EIGRP” section on page30-7.
Step2 Double-click an interface entry or choose the Interface entry and click Edit to configure the delay value
in the EIGRP parameters for an interface.
The Edit EIGRP Interface Entry dialog box appears.
Step3 In the Delay field, enter the delay time, which is in tens of microseconds. Valid values are from 1 to
16777215.