Cisco Systems PRP-2=, PRP-1=, PRP-1/R=, PRP-2/R= manual Checking the Installation

Checking the Installation

•b flash disk0: filename—Boots the file filename from the Flash disk in Flash card slot 0

•b flash disk1: filename—Boots the file filename from the Flash disk in Flash card slot 1

Caution The b flash disk0: and b flash disk1: commands are only used from the ROM monitor (Rommon>) prompt if the system fails to load normally. Do not use these commands from the router (Router>) prompt.

While the system boots, the console screen displays a script and system banner similar to the following:

Cisco Internetwork Operating System Software

IOS (tm) GS Software (PRP-P-MZ), Released Version 12.0(22)S

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Sat 10-May-02 06:02a

Step 6 Observe the system startup banner. When you start up an unconfigured system for the first time, the system automatically enters the setup facility, which determines which interfaces are installed and prompts you for configuration information for each one.

On the console screen, after the system displays the system banner and hardware configuration, the following System Configuration Dialog prompt appears:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Continue with configuration dialog? [yes/no]:

Step 7 You can either proceed with the setup facility or exit from setup and use configuration commands to configure global (system-wide) and interface-specific parameters.

You do not have to configure the interfaces immediately; however, you cannot enable the interfaces or connect them to any networks until they are configured.

	Performance Route Processor Installation and Configuration Guide
30	OL-11656-01