Cisco Systems PRP-2=, PRP-1=, PRP-1/R=, PRP-2/R= Use the command upgrade rom-monitor slot rp-slot

Upgrading to the PRP

Step 18 Upgrade the Mbus-agent-rom by using the command upgrade mbus-agent-rom all. Line cards do not need to be reloaded. If any error messages are displayed (see following example), repeat this step before contacting Cisco TAC.

MBus agent ROM upgrade failed on slot 7 (rc=5)

MBus agent ROM upgrade failed on slot 8 (rc=6)

Step 19 Upgrade the fabric downloader by using the command upgrade fabric-downloader all. The line cards do not need to be reloaded. If any error messages are displayed (see following example), repeat this step before contacting Cisco TAC.

Fabric-downloader upgrade failed on slot 7 (rc=5)

Fabric-downloader upgrade failed on slot 8 (rc=6)

Step 20 Make a note of which slot the PRP is installed in the chassis. You can use the show gsr command to view this information. In the following example, the RP is located in slot 3.

Router#	show gsr
Slot 0	type	= 3 Port Gigabit Ethernet
	state	= IOS RUN	Line Card Enabled
Slot 3	type	= Route Processor
	state	= ACTV RP	IOS Running ACTIVE
Slot 17	type	= Clock Scheduler Card(6) OC-192
	state	= Card Powered PRIMARY CLOCK
Slot 18	type	= Switch Fabric Card(6) OC-192
	state	= Card Powered
Slot 19	type	= Switch Fabric Card(6) OC-192
	state	= Card Powered
Slot 20	type	= Switch Fabric Card(6) OC-192
	state	= Card Powered
Slot 24	type	= Alarm Module(6)
	state	= Card Powered
Slot 25	type	= Alarm Module(6)
	state	= Card Powered
Slot 28	type	= Blower Module(6)

state = Card Powered

Step 21 Use the command upgrade rom-monitor slot rp-slot.

	Performance Route Processor Installation and Configuration Guide
42	OL-11656-01