Quantum Data 801GC, 801GF, 801GX manual Command Language, Command and Query Finder

Command Language

All of the commands you can only though the IEEE- 488 port on the 801G* generator are listed in a pre- vious section. All of the commands you can use with either the RS-232 or IEEE-488 port on the 801G* generator are listed in this in this section. They’re listed two ways. The Command and Query Finder section groups them by function. For example, all the commands used to change format parameter are listed under one heading. This is followed by a straight alphabetical listing of the commands. This listing also contains descriptions and expected pa- rameters.

Command and Query Finder

This listing shows all of the commands and queries supported by the current version of firmware. Each command or query will be listed under one or more of the following headings:

■Format Parameter Settings

■Format Error Checking

■Format Editor Control

■Format Memory Management

■Custom Image Drawing Primitives

■Custom Image Editor Control

■Image Memory Management

■Sequence Editor Control

■Sequence Memory Management

■Directory Editor Control

■Directory Memory Management

■System Parameter Settings

■Direct Processor Control

6-75