Quantum Data 801GC, 801GF, 801GX Putr, PUT Relative, Ratc, Pixel RATe Calibration factor, 157

PUTR	PUT Relative
Classification:	Direct processor control
Command Syntax:	PUTR <value>
Limits:	<value> = 0 to 2^(SIZE)-1
Query Syntax:	None
Description:	The PUTR command writes the specified value <value> into
	the location pointed to by the address register (see the ADDR
	command). The parameter <value> is interpreted according to
	the current setting of BASE (see the BASE command). The number
	and format of the bits written depend on the current setting of
	S I Z E ( s e e t h e S I Z E c o m m a n d ) . T h e a d d r e s s r e g i s t e r i s
	automatically incremented by SIZE bits after the current location
	has been written to.
	Note – This command will normally be used only with custom
	applications and command files created by Quantum Data.
	Indiscriminate use of this command can cause the generator to
	stop operating and / or the loss of stored data in nonvolatile
	RAM.

Other Required Cmds: PUTR expects parameters formatted according to the current radix set by the BASE command.

Example: U s e o n l y w i t h c o d e s u p p l i e d b y Q u a n t u m Data!

RATC	pixel RATe Calibration factor
Classification:	System parameter setting
Command Syntax:	RATC <factor>
Limits:	<factor> = Floating point number equal to calibration factor
	Typical min. = 0.99990
	Typical max = 1.00010
Query Syntax:	RATC?
Query Response:	<factor>
Description:	The RATC command sets an internal multiplication factor used
	in setting the pixel clock frequency. The multiplication factor
	can be set to compensate for the frequency error of the internal
	reference crystal. Having to use a factor outside of the typical
	range may indicate a failure of generator’s hardware. Re-
	initializing the generator’s memory sets the calibration factor
	to a factory-default setting of 1.00000.
	Note – The RATC parameter is a system level parameter that
	will affect the pixel clock frequency of all Formats that are
	recalled. The RATC value will be retained when the generator
	is powered down and back up again. Query the current setting
	of RATC if you are experiencing problems with the pixel clock
	or scan rate being off in frequency.
Other Required Cmds:	None
Example:	R A T C 1 . 0 0 0 0 7 / / I n c r e a s e s p i x c l k b y
	/ / f a c t o r o f 1 . 0 0 0 0 7

6-157