Cisco Systems PRP-2=, PRP-1= Preparing for Installation, Compact Flash Disk, Safety Guidelines

Preparing for Installation

Compact Flash Disk

The PRP-2 optionally includes a 1-GB compact flash disk that is installed on the PRP-2 board.

Note Non-Cisco compact flash disks are not supported.

Preparing for Installation

Installation preparation is presented in the following sections:

•Safety Guidelines, page 18

•Preventing Electrostatic Discharge, page 19

•Required Tools and Equipment, page 20

•Working with Electrical Equipment, page 20

Safety Guidelines

Before you perform any procedure in this publication, review the safety guidelines in this section to avoid injuring yourself or damaging the equipment.

The following guidelines are for your safety and to protect equipment. The guidelines do not include all hazards. Be alert.

Note Review the safety warnings listed in the Regulatory Compliance and Safety Information for Cisco 12000 Series Internet Router publication (Document Number 78-4347-xx) that accompanied your router before installing, configuring, or maintaining a line card.

•Keep the work area clear and dust free during and after installation. Do not allow dirt or debris to enter into any laser-based components.

•Do not wear loose clothing, jewelry, or other items that could get caught in the router while working with line cards.

	Performance Route Processor Installation and Configuration Guide
18	OL-11656-01