Additional Configuration and Maintenance Tasks

Step 9 Press Return.

After some interface information displays, the prompt appears as follows:

Router>

Step 10 Enter the enable command to enter enabled mode.

The prompt changes to the following:

Router#

Step 11 Enter the show start-up config EXEC command to display the enable password in the configuration file.

Step 12 Enter the configure terminal command at the EXEC prompt.

You are prompted as follows:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)#

Change the configuration register value back to its original value (noted from

Step 3.)

Change it to a value of 0x0102 (factory default) using the config-register0x value command.

Step 13 Press Ctrl-Zor type end to exit configuration mode.

Step 14 Reboot the router and enable it using the recovered password.

 

 

Performance Route Processor Installation and Configuration Guide

 

 

 

 

 

 

OL-11656-01

 

 

71

 

 

 

Page 71
Image 71
Cisco Systems PRP-2/R=, PRP-1=, PRP-1/R=, PRP-2= manual Step