Cisco Systems PRP-2/R=, PRP-1=, PRP-1/R=, PRP-2= manual Differentiating Between PRP-1 and PRP-2, 0x10

Upgrading to the PRP

Step 22 If the routine finds that an upgrade is necessary, the new code will be loaded. The router will reload once the rom-monitor upgrade has completed, without saving the running configuration.

If the rom-monitor upgrade was not required, you must now reload the router. If you are prompted to save the system configuration, answer no.

System configuration has been modified. Save? [yes/no]: no

Step 23 The router will now boot with the correct configuration as was previously running on the GRP. Perform any post-boot checks: verify that the line cards have booted, required interfaces are active, CEF is operational, IGP adjacencies have formed, and the BGP peerings are established.

Differentiating Between PRP-1 and PRP-2

You can use the software to determine whether you have installed a PRP-1 or a PRP-2. Use the command show diags prp-slot-numberand examine the value in the HW config field. If the value is 0x10, the card is a PRP-2; if the value is 0x00, the card is a PRP-1. The following example is of a PRP-2 (Note bold text in output.):

Router# show diags 5

SLOT 5	(RP/LC 5 ): Performance Route Processor
MAIN: type 96, 800-23469-01 rev ;7
	Deviation:	0
	HW config:	0x10	SW key: 00-00-00
PCA:	73-8812-02	rev 80 ver 2
	Design Release 0.0		S/N SAD0734045M
MBUS: Embedded Agent
	Test hist:	0x00	RMA#: 00-00-00		RMA hist: 0x00
DIAG: Test count: 0x00000000				Test results: 0x00000000
FRU:	Linecard/Module: FRU number not known

Route Memory: MEM-PRP/LC-1024=

MBUS Agent Software version 01.50 (RAM) (ROM version is 02.20)

ROM Monitor version 17302099

Primary clock is CSC 1 Board is analyzed

Board State is IOS Running (ACTV	RP )
Insertion time: 00:00:00 (00:31:03 ago)
DRAM size: 1073741824 bytes
Performance Route Processor Installation and Configuration Guide
OL-11656-01		43