Cisco Systems XR 12404 manual Ethernet Port Pin Signal Description

Chapter 3 Installing the Router

Connecting the PRP to an Ethernet Network

Warning The ports labeled Ethernet, 10BASE-T, Token Ring, Console, and AUX are safety extra-low voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits. Because the BRI circuits are treated like telephone-network voltage, avoid connecting the SELV circuit to the telephone network voltage (TNV) circuits.

Table 3-3	PRP RJ-45 Ethernet Receptacle Pinout
Ethernet Port Pin		Signal	Description
1		TxD+	Transmit data +
2		TxD–	Transmit data –
3		RxD+	Receive data +
4		Termination Network	No connection
5		Termination Network	No connection
6		RxD–	Receive data –
7		Termination Network	No connection
8		Termination Network	No connection

Depending on your RJ-45 cabling requirements, use the cable pinouts shown in Figure 3-12or Figure 3-13.

Figure 3-12

MDI wiring

1TxD+

2TxD–

3RxD+

6RxD–

Straight-Through Cable Pinout—Connecting MDI Ethernet Port to MDI-X Wiring

MDI-X wiring

1 RxD+

2 RxD–

6 TxD–	H11007
3 TxD+

	Cisco XR 12404 Router Installation Guide
3-21	OL-13830-02