Cisco Systems XR 12404 manual Chassis Cable-Management Bracket

Chapter 3 Installing the Router

Connecting RP and Line Card Cables

Caution Carefully adjust the interface cable in the RP or line card cable-management bracket to prevent any kinks or sharp bends in the interface cable. Kinks and sharp bends can destroy or degrade the ability of the optical fiber to propagate the signal-encoded beam of light accurately from one end of the cable to the other. Also, allow adequate strain relief in the interface cable.

Step 3 Route the cable to the chassis cable-management bracket mounted to the left side of the chassis (Figure 3-7).

•Use the screws packaged with the chassis cable management bracket kit.

Figure 3-7 Chassis Cable-Management Bracket

CLEAN CONNECTOR

CLASS 1	LASER PRODUCT
LASERPRODUKT DER			KLASSE	1
PRODUIT LASER
PRODUCTO		DE CLASSE		1
						0
	LASER DE CLASSE 1
						1
						2
						3
				CT	T-1
			EJE
					SLO	SET
					T-0	RE
					SLO
						X
						AU
						CONSOLE

TX

RX

ACTIVE

CARRIER

RX PKT

OLL				40C	48/POS-		SR-SC
C	RX		-45
			RJ
K	TX
LIN
RIT			MII
	M		GIGABIT
C				ROUTE
ICALAJOMIN						PROCESSOR
	R	OR
			MBUS
			ALARM FABRIC
			FAIL
			ENABLE
			CONSOLIDATED	SWITCH
						FABRIC

66276

	Cisco XR 12404 Router Installation Guide
3-13	OL-13830-02