Chapter 5 Maintaining the Router
Removing and Replacing the Air Filter
Use the following procedure to clean or replace the air filters.
Step 1 Grasp the small tab on the edge of the air filter and pull the tab to remove the air filter from the chassis (Figure
Tip If you are unable to lift the tab on the edge of the air filter, use a
Figure 5-4 Cisco XR 12404 router Air Filter Location
INPUT | OU | INPUT |
OK | OTPKUT OUTPUT | 100- |
| FAIL | 12A 240V |
|
| 50/80HZ |
INPUT | OU | INPUT |
OK | OTPKUT OUTPUT | 100- |
| FAIL | 12A 240V |
|
| 50/80HZ |
Step 2 Visually check the condition of the air filter.
•If the filter appears dirty, you can either vacuum or replace it.
66278
Caution Do not vacuum the air filter while it is installed in the housing.
•If the filter appears worn or torn, dispose of it in a responsible manner and install a replacement air filter.
| Cisco XR 12404 Router Installation Guide |
|